MGC-25/50/100 MGC+50/100 - Polycom

Table 6: Pending Issues (Continued)
24. ISDN After upgrade to version 7.5, the MCU
loses the ISDN clock source
configuration. In Faults file there is no
message about “NO CLOCK
SOURCE”.
25. ISDN ISDN endpoints fail to move to Video
Switching conference when the line
rate of the destination conference is
higher then the line rate at the initial
conference.
Corrections, Pending Issues and Limitations
#. Category Description ID# Remarks
26. IP+ In a mixed system with ISDN and IP,
when the clock is set to ISDN and you
set the source of the ISDN span to Null,
the IP+ card may stop responding.
27. IP+ After participants disconnect from a
conference, the LED on the card is still
On (Active).
28. IPower IPower fails to send content in a CP
conference set to Auto, H.239 P+C and
dial out.
29. MGC Manager In the H.245 Properties dialog box,
when H.239 is used, P+C is indicated
instead.
30. MGC Manager Wrong indication in the MGC Manager
when Moving IP endpoints from one
Video Switching 384 Kbps to a Video
Switching 512 Kbps conference, the
participant appears connected when
they should say secondary.
31. MGC Manager On an XPEK MCU, when extreme
packet loss occurs, the MGC Manager
can loose connection with the MCU.
32. MGC-25 The Resource Report does not display
IP capacities for line rates of 256 Kbps
and 512 Kbps.
33. MGC-25 Moving 3 IP participants from CP Quad
View to a CP COP Quad View
conference fails on the MGC25.
34. MUX When an undefined ISDN participant
connects to a CP conference using a
lower rate than the conference, the call
is rejected. Other endpoints are unable
to connect.
20685 Reconfigure the
ISDN clock.
20932
— Set the
system.cfg
(MCU_CLOCKING
section) flag:
INTERNAL_CLOCK
= YES prior to
setting the ISDN
span to Null.
17890
21066
20468
20933
21519
18307
20926 Move
participants one
at a time.
20166
51