12.03.2013 Views

MGC-25/50/100 MGC+50/100 - Polycom

MGC-25/50/100 MGC+50/100 - Polycom

MGC-25/50/100 MGC+50/100 - Polycom

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Version 7.5 - New Features List<br />

The following table lists the new features in Version 7.5.<br />

Table 1: New Features List<br />

Category Feature Name Description<br />

1. Video H.264 SD/HD in Video<br />

Switching conferences<br />

2. Video Increased Frame Rate in<br />

H.264 CP conferences<br />

3. Video H.264 up to 2 Mbps in<br />

VideoSwitching<br />

Conferences<br />

Version 7.5 - New Features List<br />

H.264 Standard Definition (SD), High<br />

Definition (HD) and VSX 8000 (version<br />

8.0) HRR resolutions are supported in<br />

Video Switching conferences.<br />

Set the system.cfg flag:<br />

ENABLE_HD_SD_IN_FIXED_MODE=<br />

YES (default =NO). When YES, the<br />

Highest Common mode is enabled.<br />

Higher Frame rates in H.264 CP<br />

conferences. The MCU now supports<br />

frame rates up to 30 FPS in CP<br />

conferences.<br />

In H.264 VideoSwitching Conferences,<br />

the maximum Line Rate capability is<br />

1920 Kbps.<br />

Supported in <strong>MGC</strong> version 7.03.<br />

4. Video H.264 Fixed Mode H.264 Fixed mode can be used with<br />

cascaded conferences by setting the<br />

H.264_VSW_AUTO flag to YES. These<br />

flag settings forces all endpoints to use<br />

predefined conference resolution and<br />

frame rates.<br />

5. Video Video Support for Start<br />

Conference requires<br />

Chairperson<br />

6. IP H.323 dial-out automatic<br />

redial<br />

This feature is now available for video<br />

conferences.<br />

When the conference is set to Wait for<br />

Chairperson and participants connect to<br />

the conference before the chairperson,<br />

the conference is placed on hold.<br />

When an H.323 dial-out call fails to<br />

connect because the endpoint could not<br />

be reached (for example, the endpoint is<br />

busy), the system can be set to<br />

automatically redial the endpoint.<br />

Set the system.cfg flag:<br />

ENABLE_H323_REDIAL=YES.<br />

7. IP Direct IP Dial-in The MCU supports two new IP Dial-in<br />

methods:<br />

• Direct Endpoint Dialing (Without<br />

Gatekeeper)<br />

• IP to ISDN Gateway Call (without<br />

Gatekeeper)<br />

1

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!