Sniffer Adaptive Application Analyzer: Adaptive Mode ... - NetScout

EARLY FIELD TRIAL
Raw Capture Mode Postcapture Analysis
Multiple filter mode allows you to select two or more display
filters to apply. Select options from the list of available filters
to create a single filter using combinations of existing filters.
If you select a parent category, all the filters within the
category are selected automatically. When the parent
category is unselected, all the filters within the category are
deselected.
NOTE: When the combination filter is applied, it acts as an
“OR” between the selected filters. Because of this, Multiple
Filter Mode may return unexpected results when using Exclude
filters (filters set to remove matching traffic). See Multiple
Filter Mode and Exclude Filters on page 182 for details.
Single Filter Mode. If you are using only a single filter, leave
Single Filter Mode enabled and check the box corresponding to
the filter you want to use.
Single filter mode functions as a regular, single filter. With
the Single Filter Mode option, you are limited to only one
filter selection in the Select Filter dialog box. Selecting one
filter automatically deselects the previously selected filter.
Selecting a “parent” filter is not a valid filter. You must
specify a single filter within the parent grouping.
3 Use the Select matching, Clear selected, and Apply on
selected set options to specify how the display filter will be applied
and its results returned. See Filtered Tabs or Marked Frames? on
page 176 and The “Apply on Selected Set” Option on page 177 for
more information.
4 Click OK to apply the selected filter(s) on the active Decode tab.
User’s Guide 181