Sniffer Adaptive Application Analyzer: Adaptive Mode ... - NetScout

EARLY FIELD TRIAL
Raw Capture Mode Postcapture Analysis
Sniffer Adaptive Application Analyzer sifts through the packets in
the active tab, looking for matches. Then, it returns the matching
packets, either in a new tab at the bottom of the display window (b
in Figure 8-7 on page 177), or by “selecting” all matching packets
in the Summary pane (a in Figure 8-7 on page 177). You choose
which action the Console takes by setting the options in the
Display > Display Setup > Packet Selection tab (see Display
Setup > Packet Selection Options on page 195).
Combining Filter Components (“Add to Last Filter”)
You can use the Add to Last Filter button to add a new filter
component from the currently selected packet to the last filter used in
the Define Filter dialog box.
For example, if the last filter you created was based on the Source Port
in the selected frame, you could add source and destination addresses
to the same filter by setting the Automatic Filter Type Selection
dropdown to IP Addresses and clicking the the Add to Last Filter
button.
To use the Add to Last Filter button:
1 In a Decode tab, select the packet to use as a filter source.
2 Use the Automatic Filter Type Selection dropdown in the Decode
toolbar to specify which portion of the packet you want to use as a
filter (Figure 8-9).
Figure 8-9. Selecting the Automatic Filter Type
You can select from the same options available for Automatic
Display Filters, as described in Table 8-7 on page 174.
3 Click the Add to Last Filter button .
User’s Guide 179