www.hella.com

Flasher Units
Electronic turn signal and hazard flasher units for all applications,
12V and 24V
Without trailer
With trailer
Turn signals
The electronic turn signal and hazard warning flasher units from Hella are available with
single-circuit, two-circuit or three-circuit system.
Single-circuit flasher units
Range of application:
Passenger cars, passenger cars with trailer, transporters, vans, small buses,
trucks (light to medium-heavy class), agricultural vehicles, commercial vehicles
Hazard warning flashers
All flasher lamps on one side of the vehicle including trailer are switched and controlled by an internal power and control circuit in the flasher unit.
A measuring resistor is responsible for the bulb failure control.
The single-circuit flasher unit allows reliable control of up to four flasher lamps per vehicle side.
A specific fault source display (towing vehicle/trailer) is not possible with single-circuit flasher units.
Single-circuit flasher units
Electronic turn signal and hazard warning
flasher units, for vehicles with 12V system,
small housing for fit equipment carrier.
With E-control,
in the event of bulb failure the indicator lamp
starts to flash quickly.
Part no.
Pk.
4DB 003 750-711 1
Turn signal and hazard warning flasher unit,
3-pole, without bracket,
12V
4DB 003 750-717 150
4DB 003 750-721 1
with bracket,
12V
Electronic turn signal and hazard warning flasher units,
for vehicles with 12V system. With EP-control,
in the event of bulb failure on the towing vehicle the indicator lamp starts to
flash quickly, in the event of bulb failure on the trailer the indicator lamp
goes out. Suitable hazard warning flasher switch 6HF 001 579-052 (Pk.1)
for vehicles with separate stop/flasher lamp function.
Part no.
Pk.
C2 and 31 connection on top
4DM 003 360-021 1
Turn signal and hazard warning flasher unit,
4-pole, 12V
4DM 003 360-027 200
1.34 EE 11