User Guide (Printer/Scanner) - Fuji Xerox Worldwide

Setting up Network
2
32
2.4 NetWare
This section describes how to connect the machine to a Novell NetWare-network.
2.4.1 System Structure
The system structure is as follows:
As a network OS, this machine supports Novell NetWare (version 5.x, 6.x) and
the printer server (PServer) mode only using binary and NDS.
In the PServer mode, this machine will be the print server and will print jobs from
the print queue. The created printer will use up one user license of the file server.
You can print from the machine in an NDPS environment by using Novell NDPS Gateway. Before you
start printing, set the machine to operate in a NetWare print environment, or start LPD. You need to
set them as the Gateway destination when you set up the Novell NDPS Gateway. However, the
attributes that can be acquired and set in NDPS are not supported.
2.4.2 Interface
■Supported interface
● 100Base-TX
● 10Base-T
■Supported frame type
● Ethernet II
● IEEE802.3
● IEEE802.3/IEEE802.2
● IEEE802.3/IEEE802.2/SNAP
This machine will send out packet of each frame type on the connected network,
and automatically activate to the frame type that responded first.
However, if other protocol exists together on the same network, use Ethernet II.