User Guide (Printer/Scanner) - Fuji Xerox Worldwide

2.1.2 Setting Procedure
Procedure
The procedure is as follows:
2.1 Windows Network (SMB)
1 Configuring this machine:
Using either the touch panel display or CentreWare Internet Services, set the
port for SMB to Enabled (default: Disabled).
● “1.4 Setting Port” (P. 18) for details on setting the port.
● More detailed settings can be done by using CentreWare Internet Services. For details, see
“Chapter 5 Configuring From Computer (CentreWare Internet Services)” (P. 105).
● By overwriting the config.txt files of this machine, the setting/changing of SMB can be done on the
Windows computer.
2 Configuring the computer:
Install the printer driver.
● When using NetBEUI as the transport protocol, check that the NetBEUI protocol has been installed
on the host device. If not installed, see the manual of the OS used to install it.
● When using TCP/IP as the transport protocol, check that the TCP/IP protocol has been installed on
the host device. If not installed, see the manual of the OS used to install it. IP address is needed on
both the host device and this machine.
“3.4 Installing/Uninstalling the Printer Drivers” (P. 50) for details on how to install the printer
driver.
Setting up Network
2
27