User Guide (Printer/Scanner) - Fuji Xerox Worldwide

Setting Printer Environment 18
1
1.4
Setting Port
This section describes the procedure on activating the port to be used for printing after the
IP address has been set or checked.
You can activate the port by using either the System Administration Mode through the touch
panel display or CentreWare Internet Services.
If the port has been used already in the Enabled state, the procedure in this section is not
necessary. If the needed port is in the Disabled state, carry out the procedure.
To check if the port is Enabled, either carry out the following procedure in “1.4.1 Activating
Port” and then check the port status; or see “6.6 Printing Reports/Lists” in “Part 1 Hardware”
of the User Guide (Copier) to print out the System Settings List and then check the item
under Communication Settings.
● “Chapter 5 System Administration Mode Settings” in “Part 1 Hardware” of the User Guide (Copier) for details
on System Administration Mode and the ports that can be set.
● “Chapter 5 Configuring From Computer (CentreWare Internet Services)” (P. 105) for details on CentreWare
Internet Services.
1.4.1 Activating Port
Procedure
The following procedure describes how to set the LPD port to Enabled (default:
Disabled) using the touch panel display.
1 On the control panel, press Password/System Settings.
Either the System Administrator Menu screen or System Administrator – Password Entry screen will
be displayed.
If the System Administrator Menu screen is displayed, proceed to step 2.
System Administrator Menu
User Mode System Settings