User Guide (Printer/Scanner) - Fuji Xerox Worldwide

1.3 Setting IP Address
9 Enter the IP address using the numeric keypad.
Once three digits are entered, the cursor will move automatically to a next bit. To move to the next bit
before three digits are entered, select the Next button.
● Enter the address in a xxx.xxx.xxx.xxx format. xxx refer to the value between 0 to 255. However, the
following address cannot be entered: 224 to 225.xxx.xxx.xxx and 127.xxx.xxx.xxx.
● To correct a invalid entered value, press the C button on the control panel, and then re-enter.
5. TCP/IP - IP Address
. . .
10 Select Save once you have entered the IP address.
The Protocol Settings screen is displayed.
11 If necessary, repeat steps 8 to 10 to set the subnet mask and gateway
address.
● The subnet mask and gateway address cannot be set if the IP address has not been entered.
● Enter the IP address in a xxx.xxx.xxx.xxx format.
● Enter the subnet mask using a combination of the following values: 0, 128, 192, 224, 248, 252, 255.
However, 0 cannot be entered as one of the middle bits.
● Enter the gateway address within the limit of 0 to 255. However, the following address cannot be
entered: 224 to 225.xxx.xxx.xxx and 127.xxx.xxx.xxx.
● When the gateway adress does not need to be set, enter “0.0.0.0”.
12 Once you have entered the IP address, select Close repeatedly until
the System Settings screen is displayed.
13 Select Close.
The machine will reboot and the display will return to the previous screen prior to this procedure.
Next
Cancel
Save
Setting Printer Environment 1
17