User Guide (Printer/Scanner) - Fuji Xerox Worldwide

Appendix
252
F Troubleshooting When Using NetWare
Cause Verification Action
The user name or group name of
the person sending the job is not
registered in print server user of
the print queue.
The print queue that sent the
print job is not assigned to the
printer.
The settings of the data format
of print job are not similar to that
of the printing environment of the
workstation.
A print queue which exceeded
the maximum number of supported
queues of the printer has
been set.
The slave file server is not set
(bindery service mode).
Using NWADMIN from the workstation,
check if the user name
or group name of the person
sending the job is registered in
User of the target print server. *
Using NWADMIN from the workstation,
check if the target printer
is assigned to the serviced
printer in the list under User of
the target print queue.*
⎯
Using NWADMIN from the workstation,
check if the desired print
queue is assigned to the print
queue list under User of the target
print. *
Using PCONSOLE from the
workstation, check if the slave
file server is registered in Service
NetWare Server under the
print server corresponding to the
Print Server Information. *
Printer type is wrong. Using PCONSOLE from the
workstation, check if the following
settings are set under Printer
Information > Printer > Printer
xxx Environment: Printer= Parallel,
Port= LPT1, Position= Auto
mode (local).*
The slave file server setting is
wrong (bindery service mode).
Using PCONSOLE from the
workstation, check if printer type
is set as Defined under Printer
Information > Printer > Printer
xxx Environment.*
1. Re-send the print job to the
print queue with the registered
user name or group
name of the person sending
the job registered in User of
Print Server Information.
2. Using NWADMIN from the
workstation, register the user
name or group name of the
person sending the job at
User of the target print
server. *
1. Re-send the print job to a
print queue assigned to the
printer. *
2. Using NWADMIN from the
workstation, add the target
queue as an addition to User
of the target printer. *
For workstation using Windows,
disable the output function of
Ctrl-D.
Re-send the print job to a print
queue assigned to the printer. *
After registering the slave file
server using PCONSOLE from
the workstation, reflect the setting
parameters.
Using PCONSOLE from the
workstation, set Printer= Parallel,
Port= LPT1, Position= Auto
mode (local) and reflect the setting
parameters. *
If it is not Defined, change it to
Defined and then reflect the setting
parameters.*