User Guide (Printer/Scanner) - Fuji Xerox Worldwide
User Guide (Printer/Scanner) - Fuji Xerox Worldwide
User Guide (Printer/Scanner) - Fuji Xerox Worldwide
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
F Troubleshooting<br />
When<br />
Using NetWare<br />
This section describes the possible causes, ways of verification, and the recommended<br />
actions for errors which may occur when using NetWare.<br />
F.1 When Not Printed<br />
Cause Verification Action<br />
The network component board<br />
(e.g. HUB) is not compatible with<br />
the automatic setting of the<br />
frame type.<br />
There is a breakdown in the network<br />
from the workstation to the<br />
printer.<br />
The user name or group name of<br />
the person sending the job is not<br />
registered in <strong>User</strong> of the print<br />
queue.<br />
Job sending to the print queue is<br />
prohibited.<br />
Check if the data link lamp of the<br />
network component board connected<br />
to this machine is on.<br />
Check if the frame type of the file<br />
server in the network is similar.<br />
Using NWADMIN from the workstation,<br />
check if the target printer<br />
object can be seen. *<br />
Using NWADMIN from the workstation<br />
and referring to the target<br />
queue object, check if the user<br />
name or group name of the person<br />
sending the job is registered<br />
in <strong>User</strong>. *<br />
Using PCONSOLE, check if Yes<br />
is set for <strong>User</strong> can register with<br />
the queue at the Current Queue<br />
Status of Print Queue.<br />
Using NWADMIN from workstation,<br />
check if the operator flag is<br />
checked at Recognition of the<br />
target print queue. *<br />
From this machine, set up the<br />
frame type specified to the file<br />
server which you want to connect<br />
to.<br />
Replace the network cable<br />
between the workstation and the<br />
printer that cannot be used for<br />
transmitting data.<br />
1. Re-send the print job to the<br />
print queue with the registered<br />
user name or group<br />
name of the person sending<br />
the job registered in <strong>User</strong> of<br />
Print Queue.<br />
2. Using NWADMIN from the<br />
workstation, register the user<br />
name or group name of the<br />
person sending the job at<br />
<strong>User</strong> of Print Queue*<br />
Using PCONSOLE, set to Yes.<br />
Using NWADMIN from workstation,<br />
check if each item of the<br />
operator flag is checked at Recognition<br />
of the target print<br />
queue. *<br />
Appendix<br />
251