User Guide (Printer/Scanner) - Fuji Xerox Worldwide

Appendix
240
C Precautions/Limitations
■When LPD Spool is set to Off (non-spool mode)
All print data spooled to the receive buffer of this machine, including data in the
process of printing, will be deleted. When the power is turned on again, the print
data will not be found.
However, if the power is turned off immediately after the print data has been
sent, the print data may be stored in the host device. In this case, when the
power is turned on again, the stored print data will be printed first even if new
print data has been sent.
During printing
■When LPD Spool is set to Hard Disk or Memory
If the print data is larger than the hard disk or the remaining memory capacity at
the point of receiving print data, the data will not be received.
When the print data has exceeded the receiving capacity, some host devices may re-send the data
immediately. When this occurs, the host device appears as if it has crashed. To rectify the situation,
stop the host device from sending print data.
■When LPD Spool is set to Off (non-spool mode)
If the machine has accepted a print request from a host device, it cannot accept
any print request from other host device.
■When the IP address or computer name of the host device is changed
When the IP address or computer name of the host device is changed, it may not
be able to process enquiry or delete request from this machine correctly. Ensure
that this machine is free of print data in the receive buffer, and then turn the
power off/on.
You can use the touch panel display to stop/eject print data spooled to the receive buffer of this
machine. For details on the way to do this, see “7.2.8 Forcibly Outputting Data Wait Documents” in
“Part 1 Hardware” of the User Guide (Copier) or “3.6.2 Canceling Printing From Printer” (P. 58) of
“Part 1 Printer”.