User Guide (Printer/Scanner) - Fuji Xerox Worldwide

C.2 TCP/IP (LPD)
The precautions/limitations of using TCP/IP (LPD) are as follows:
Setting up this machine
C Precautions/Limitations
● Be very careful in setting up IP addresses. IP addresses are addresses controlled
as an entire system. Consult your network administrator before defining
any address.
● Depending on the network environment used, it may be necessary to set the subnet
mask and gateway. Consult your network administrator before defining the
needed item.
● If setting the port to Enabled leads to insufficient memory, the port status may
be set to Disabled automatically. In this case, either set the port to Disabled
when it is not used or change the memory allocation capacity.
● Specify the size for the receive buffer memory (LPD spool) as required by the
environment in use. If the size of the receive buffer memory (LPD spool) is
smaller than the transmitted data, the data may not be received.
Setting up host machine
● Be very careful in setting up IP addresses. IP addresses are addresses controlled
as an entire system. Consult your network administrator before defining
any address.
● Consult the Network Information Service (NIS) administrator when setting network
(such as IP address) by a host being used under NIS.
Switching off power
Take note of the following points when turning off the power of this machine:
■When LPD Spool is set to Memory
All print data spooled to the printer memory, including data in the process of
printing, will be deleted. When the power is turned on again, the print data will
not be found.
However, if the power is turned off immediately after the print data has been
sent, the print data may be stored in the host device. In this case, when the
power is turned on again, the stored print data will be printed first even if new
print data has been sent.
■When LPD Spool is set to Hard Disk
All print data spooled to the hard disk of this machine, including data in the process
of printing, will be saved. When the power is turned on again, the stored
print data will be printed first even if new print data has been sent.
Appendix
239