User Guide (Printer/Scanner) - Fuji Xerox Worldwide

Setting Printer Environment 10
1
1.2
Connecting Interface
Cable
Use the parallel interface to connect this machine to a host device directly. Use an Ethernet
interface to connect to a network. You can also use the Token Ring (option) to make a connection.
1.2.1 Connecting by Parallel Interface
Procedure
The following procedure describes how to connect with the parallel interface.
To connect to a host device using parallel interface, you will need the parallel interface cable provided
by our company as an optional product. For details on this optional product, see “Appendix B
Optional Accessories” in “Part 3 Appendix” of the User Guide (Copier).
1 Insert the interface cable connector to
the parallel interface connector of this
machine and secure it by the wire clips
on both sides.
2 Connect the other end of the interface
cable connector to the host device.
3 Turn on the power of the host device.
4 Turn on the power of the machine.
If necessary, you may select the following settings:
● Port Status (Default: Enabled)
● Print Mode (Default: Auto)
● PJL (Default: Enabled)
● Auto Eject Time (Default: 30 Seconds)
● Adobe Communication Protocol (Default: Standard)
● Bi-directional Communication (Default: Enabled)
For details on the items to be set, see “5.6 Network Settings” in “Part 1 Hardware” of the User Guide
(Copier).
● Adobe Communication Protocol can be set when the PostScript Software Kit (option) has been
installed.