User Guide (Printer/Scanner) - Fuji Xerox Worldwide

3.3 Configuring Scan Settings
9 If necessary, configure other scan settings.
10 Press Start.
Scanning of the document will begin and the scanned data will be saved in the specified mailbox.
3.3.6 Scan Size
Procedure
You can configure the scan size for scanning.
Set the scan size when scanning documents of non-standard sizes or to a different
size.
If the scan size is set, scanning will be done according to the specified size
regardless of the actual size of the document loaded.
Options for setting scan size are as follows:
● Auto Size Detect
Detects the document size automatically.
● Standard Sizes
Choose from the 11 set sizes: A3 , A4 , A4 , A5 , B4 , B5 , 11×17" , 8.5×11" ,
8.5×11" , Photo 2L Size , Photo L Size .
● Custom
Specifies the size in the range of the document glass, 15 – 432 mm for X (horizontal direction) and
15 – 297 mm for Y (vertical direction) in units of 1 mm. When setting custom size, use the ruler
markings surrounding the document glass as a guide.
● Among the buttons of Scan Size, the default values of all sizes except Auto Size Detect can be
changed in the System Administration Mode. For details on the way to change, see “5.8 Scan Mode
Settings” in “Part 1 Hardware” of the User Guide (Copier). The default values are set as A3 ,
A4 , A4 , A5 , B4 , B5 , 11×17" , 8.5×11" , 8.5×11" , Photo 2L Size , Photo L
Size .
● If the size cannot be automatically detected, an error message will prompt you to enter the document
size.
1 Load the document to be scanned.
“2.2 Loading Documents” (P. 147) for details on loading documents.
Scanning With Mailbox 3
171