RPi Easy SD Card Setup - eLinux.org

gcc -o blink -l rt -I ../../src ../../src/bcm2835.c blink.c
// sudo ./blink
//
// Author: Mike McCauley (mikem@open.com.au)
// Copyright (C) 2011 Mike McCauley
// $Id: RF22.h,v 1.21 2012/05/30 01:51:25 mikem Exp $
#include
// Blinks on RPi pin GPIO 11
#define PIN RPI_GPIO_P1_11
int main(int argc, char **argv)
{
// If you call this, it will not actually access the GPIO
// Use for testing
// bcm2835_set_debug(1);
}
if (!bcm2835_init())
return 1;
// Set the pin to be an output
bcm2835_gpio_fsel(PIN, BCM2835_GPIO_FSEL_OUTP);
// Blink
while (1)
{
// Turn it on
bcm2835_gpio_write(PIN, HIGH);
}
// wait a bit
delay(500);
// turn it off
bcm2835_gpio_write(PIN, LOW);
// wait a bit
delay(500);
return 0;
GPIO Driving Example (Perl)
This must be done as root. To change to the root user:
sudo su -
Supports GPIO and SPI interfaces. You must also get and install the bcm2835 library.
Details and downloads from http://www.open.com.au/mikem/bcm2835 You must then get
and install the Device::BCM2835 perl library from CPAN http://search.cpan.org/~mikem/
Device-BCM2835-1.0/lib/Device/BCM2835.pm
use Device::BCM2835;
use strict;