You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Then find where it says<br />
XKBLAYOUT=”gb”<br />
and change the gb to the two letter code for your country. [1]<br />
(http://www.raspberrypi.<strong>org</strong>/phpBB3/viewtopic.php?p=78325#p78325)<br />
Slow keyboard mapping<br />
If you have remapped your keyboard and get a very long delay during the keyboard<br />
mapping at startup, type the following once on the command line after you have logged<br />
in:<br />
sudo setupcon<br />
No USB device works, with known good PS, <strong>SD</strong> card, KB<br />
There has been more than one report [13][14][15] of a R-Pi booting but not getting USB<br />
input, using a known-good power supply, <strong>SD</strong> card, and keyboard. The more common<br />
cause for no USB devices working is low power supply voltage from bad PSU, cable, or<br />
USB hub, but in this case the problem was no clock signal present at the LAN9512 USB/<br />
Ethernet chip "IC3", and the solution was to reflow the solder on the 25 MHz crystal<br />
"X1" on the bottom side of the board. Or return the board for a replacement, but before<br />
making this conclusion, confirm known good peripherals. A significant number of USB<br />
keyboards are not compatible with R-Pi. As of June 1 2012, Eben reported [16] that only<br />
about 1 in 1000 shipped R-Pi boards have been found to have a hardware fault of any<br />
kind.<br />
Updating firmware<br />
Check your firmware version<br />
Using the latest firmware version may help various problems with <strong>SD</strong> card and display<br />
compatibility. Check the kernel version with:<br />
uname -a<br />
Linux <strong>RPi</strong> 3.1.19 #1 PREEMPT Fri Jun 1 14:16:38 CEST 2012 armv6l GNU/Linux<br />
And the GPU firmware with:<br />
/opt/vc/bin/vcgencmd version<br />
May 31 2012 13:35:03
Change language