SGI® 10-Gigabit Ethernet Adapter II User's Guide - SGI TechPubs ...

More documents

Recommendations

Info

2: Connecting the Adapter to a Network Connecting with a Copper Cable Fiber-optic connector Figure 2-1 Connecting the Fiber-Optic Cable To connect your adapter to a network with a copper cable, do the following: 1. Insert the connector on one end of the copper cable into the adapter, as shown in Figure 2-2. Ensure that the connector is inserted completely into the jack. 2. Insert the connector on the other end of the copper cable into the connector on the Ethernet switch or on another computer system (as appropriate). Note: If your network connects to an Ethernet switch, consult the operating manual for the switch to ensure that the switch port is enabled and configured correctly. 12 007-5476-001
Copper connector Figure 2-2 Connecting the Copper Cable Connecting to a Network 007-5476-001 13
Page 1 and 2: SGI ® 10-Gigabit Ethernet Adapter
Page 3: Canadian Department of Communicatio
Page 7 and 8: Contents Figures . . . . . . . . .
Page 9: Figures Figure 1-1 SGI 10-Gigabit E
Page 13 and 14: Important Information ! ! About Thi
Page 15 and 16: About This Book • SGI Altix 450 S
Page 17: Product Support Reader Comments Abo
Page 20 and 21: 1: Features and Capabilities Adapte
Page 22 and 23: 1: Features and Capabilities Cablin
Page 24 and 25: 1: Features and Capabilities Copper
Page 27 and 28: Chapter 2 Installing the Adapter 2.
Page 29: Connecting with a Fiber-Optic Cable
Page 33 and 34: Chapter 3 Verifying Functionality 3
Page 35 and 36: Verifying That the Adapter Is Prope
Page 37 and 38: Chapter 4 4. Performance Tuning The
Page 39 and 40: The following entry dumps the curre
Page 41 and 42: Glossary acknowledge (Ack) packet T
Page 43 and 44: C Index cabling copper, 6, 12 fiber

SGI® 10-Gigabit Ethernet Adapter II User's Guide - SGI TechPubs ...

Create successful ePaper yourself

Delete template?

Save as template?