BULETINUL INSTITUTULUI POLITEHNIC DIN IAŞI - Universitatea ...

BULETINUL INSTITUTULUI POLITEHNIC DIN IAŞI
Publicat de
Universitatea Tehnică „Gheorghe Asachi” din Iaşi
Tomul LVI (LX), Fasc. 2, 2010
Secţia
CONSTRUCŢII DE MAŞINI
CONTRIBUTIONS TO THE ELABORATIONS OF A
GRAPHICAL METHOD FOR PROFILING OF TOOLS WHICH
GENERATE BY ENVELOPING
II. APLICATION FOR RACK-GEAR TOOL’S PROFILING
SILVIU BERBINSCHI, VIRGIL TEODOR,
NICOLAE DUMITRAŞCU and NICOLAE OANCEA
Abstract. In this paper is presented an application of the general algorithm
regarding the tool’s profiling which generate by enveloping, by rolling method,
respectively the rack-gear tool generating an ordered curl of profiles. They are
presented the successive steps of this process and, also, numerical examples
regarding the crossing profile of the rack-gear tool. The method quality is proofed
by comparing the obtained results with results obtained for the same problem,
using one of the analytical methods, the Willis method, and software developed in
Java.
Key words: enveloping surfaces, rack-gear tool, graphical design method.
BY
1. Introduction
It was present the general algorithm for profiling the tools generating by
enveloping, by the rolling method, in the CATIA design environment.
In following are presented an application of the proposed algorithm for
rack-gear tool’s profiling generating ordered curl profiles, for a hexagonal shaft,
as so as, the comparison for the profile determination of the rack-gear tool with
results obtained by analytical methods, based on specialised software, realised
in Java [6], [7].
In the paper entitled “Contributions to the Elaborations of a Graphical Method for
Profiling of Tools Which Generate by Enveloping. I. Algorithm” is proposed a new