DRIP AND MICRO IRRIGATION CATALOG - Dingo
DRIP AND MICRO IRRIGATION CATALOG - Dingo
DRIP AND MICRO IRRIGATION CATALOG - Dingo
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
TM<br />
Installation and Technical Data<br />
1. 2 3 4<br />
1. FLUSHING THE SYSTEM<br />
Unscrew the caps from the end of the DURA-FLO TM dripperline. Flush out the system one cap at a time until<br />
all dirt/debris has been removed. Screw the caps back on (hand tighten only). There is a washer inside the cap – be sure not to lose it.<br />
2. TEST THE SYSTEM<br />
Switch on the system and check for leaks. Evaluate if the coverage is adequate. Adjust the coverage as needed by either moving the DURA-FLO TM<br />
dripperlines or adding additional DURA-FLO TM dripperline as needed. (Keep in mind that the maximum amount of DURA-FLO TM dripperline per<br />
zone is 200 feet). When checking the moisture levels, do not only look at the surface water. Dig down a few inches<br />
to the root area. This is where it counts. Also keep in mind that water will spread below the surface by capillary action.<br />
3. TURNING IT ON<br />
The watering schedule depends on a variety of factors. As a starting off point, try running the system for 30 – 45 minutes a day, 3-5 times a<br />
week. After a few cycles, adjust watering schedule as required.<br />
4. COVER <strong>DRIP</strong>PERLINE WITH MULCH<br />
To hide the DURA-FLO TM dripperline, mulch can be used. For dense plantings or for ground cover, this may not be necessary.<br />
TECHNICAL DATA<br />
Part # Description Information<br />
SF-GR-7412-01 1/2" DURA-FLO TM dripperline • 0.600" ID x 0.700" OD<br />
• Discharge rate of 0.9 gph @<br />
20psi and 1.2 gph @ 30 psi<br />
• Maximum length of run = 200'<br />
• Maximum pressure = 45 psi<br />
A 700 GR/50 1/2" tubing • 0.600" ID x 0.700" OD<br />
• Maximum pressure = 45 psi<br />
PRHHGR 30 Pressure Regulator • Regulated pressure of 30 psi<br />
• Flow range of 0.1 to 7.0 gpm<br />
• Maximum inlet pressure of 100<br />
psi<br />
FTEE 150 Filter • Maximum flow rate of 8 gpm<br />
• 150 mesh stainless<br />
steel element<br />
• Maximum operating<br />
pressure of 75 psi<br />
Tubing is made from virgin LLDPE (Dow 7510) and contains an inhibitor to prevent ultra violet ray degradation.<br />
Over a period of time fading of the dark green DURA-FLO TM dripperline is to be anticipated. This will not reduce<br />
the integrity of the DURA-FLO TM dripperline.<br />
9