RU 26 - emmerson

MANUAL SETTING
1. Look up the four-digit code for your brand
and type of equipment in the Code List .
2. Turn on the equipment you want the remote
to control, and point the remote toward it.
3. Press the Device key you want the remote to
control (e.g. TV, DVD, VCR, SAT, etc), and
release, the LED flash once.
4. Press and hold the [SET] Key until the LED
turn on.
5. Press the four-digit code for your
equipment. Each time you press, LED
flashes and turn on.
6. Aim the remote at the device, press the
corresponding device button and press a
button to check if that button works. But not
[OK] button. For example, press the POWER
button to see if it can turn off the device.
Check that the other buttons of the remote is
operating the corresponding functions of the
device.
7. Press [OK] to save the correct code if all the
function keys are working.
Notes :
1. If the LED flash trice and turn on, it indicate
the code is not existing or effected. Please
check the codes again. Please press [SET]
again, the LED flash once. Then enter a new
code from the code list.
2. If no key on your remote is pressed for 30
seconds, the programming process will stop.
3. Aim the remote at the device, press the
corresponding device button and press a
button to check if that button works. For
example, press the POWER button to see if