CANopen Programmer's Manual - Maccon.de

More documents

Recommendations

Info

3: Device Control, Configuration, and Status CANopen Programmer’s Manual AMPLIFIER DATE CODE INDEX 0X6510, SUB-INDEX 2 Type Access Units Range Map PDO Memory String RO - - NO - Description Date of manufacture of the amplifier. AMPLIFIER PEAK CURRENT INDEX 0X6510, SUB-INDEX 3 Type Access Units Range Map PDO Memory Integer 16 RO 0.01 amps - NO - Description The amplifier's peak current rating. AMPLIFIER CONTINUOUS CURRENT INDEX 0X6510, SUB-INDEX 4 Type Access Units Range Map PDO Memory Integer 16 RO 0.01 amps - NO - Description The amplifier's continuous current rating. AMPLIFIER PEAK CURRENT TIME INDEX 0X6510, SUB-INDEX 5 Type Access Units Range Map PDO Memory Integer 16 RO milliseconds - NO - Description The maximum time for which the amplifier is rated to output peak current. AMPLIFIER MAXIMUM VOLTAGE INDEX 0X6510, SUB-INDEX 6 Type Access Units Range Map PDO Memory Integer 16 RO 0.1 volts - NO - Description Maximum bus voltage rating for amplifier. AMPLIFIER MINIMUM VOLTAGE INDEX 0X6510, SUB-INDEX 7 Type Access Units Range Map PDO Memory Integer 16 RO 0.1 volts - NO - Description Minimum bus voltage rating for amplifier. AMPLIFIER VOLTAGE HYSTERESIS INDEX 0X6510, SUB-INDEX 8 Type Access Units Range Map PDO Memory Integer 16 RO 0.1 volts - NO - Description Hysteresis for maximum bus voltage cut-out. AMPLIFIER MAXIMUM TEMPERATURE INDEX 0X6510, SUB-INDEX 9 Type Access Units Range Map PDO Memory Integer 16 RO degrees centigrade - NO - Description Temperature limit for amplifier. 84 Copley Controls
CANopen Programmer’s Manual 3: Device Control, Configuration, and Status AMPLIFIER TEMPERATURE HYSTERESIS INDEX 0X6510, SUB-INDEX 10 Type Access Units Range Map PDO Memory Integer 16 RO degrees centigrade - NO - Description Hysteresis value for amplifier over temperature cut-out. AMPLIFIER CURRENT LOOP PERIOD INDEX 0X6510, SUB-INDEX 11 Type Access Units Range Map PDO Memory Integer 16 RO 10 nanoseconds - NO - Description Current loop update period in 10-nanosecond units. AMPLIFIER SERVO LOOP PERIOD INDEX 0X6510, SUB-INDEX 12 Type Access Units Range Map PDO Memory Integer 16 RO - - NO - Description Servo loop update period as a multiple of the current loop period. AMPLIFIER TYPE CODE INDEX 0X6510, SUB-INDEX 13 Type Access Units Range Map PDO Memory Integer 16 RO - See Description, below. NO - Description Identifies the specific amplifier model. Also known as Amplifier Hardware Type. Identical to Product Code (index 0x1018, Sub-index 2, p. 74). Go to page 74 (index 0x1018, Sub-index 2) for a table of current defined values. CURRENT CORRESPONDING TO MAX A/D READING INDEX 0X6510, SUB-INDEX 14 Type Access Units Range Map PDO Memory Integer 16 RO 0.01 amps - NO F Amplifier current corresponding to maximum A/D reading. VOLTAGE CORRESPONDING TO MAX A/D READING INDEX 0X6510, SUB-INDEX 15 Type Access Units Range Map PDO Memory Integer 16 RO 0.1 volts - NO F Amplifier voltage corresponding to maximum A/D reading. ANALOG INPUT SCALING FACTOR INDEX 0X6510, SUB-INDEX 16 Type Access Units Range Map PDO Memory Integer 16 RO - - NO F Amplifier analog input scaling factor. AMPLIFIER MINIMUM PWM OFF TIME INDEX 0X6510, SUB-INDEX 17 Type Access Units Range Map PDO Memory Integer 16 RO 10 ns - NO F This fixed amplifier parameter gives the minimum amount of time for which all PWM outputs must be disabled for each current loop cycle. Copley Controls 85
Page 1:
CANopen Programmer’s Manual Part
Page 5 and 6:
CANopen Programmer’s Manual Table
Page 7 and 8:
About this Manual CANopen Programme
Page 9 and 10:
About this Manual CANopen Programme
Page 11 and 12:
CHAPTER 1: INTRODUCTION This chapte
Page 13 and 14:
CANopen Programmer’s Manual 1: In
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34: CANopen Programmer’s Manual 1: In
Page 39 and 40: CHAPTER 2: NETWORK MANAGEMENT This
Page 41 and 42: CANopen Programmer’s Manual 2: Ne
Page 51 and 52: CHAPTER 3: DEVICE CONTROL, CONFIGUR
Page 53 and 54: CANopen Programmer’s Manual 3: De
Page 83: CANopen Programmer’s Manual 3: De
Page 127 and 128: CHAPTER 4: CONTROL LOOP CONFIGURATI
Page 129 and 130: CANopen Programmer’s Manual 4: Co
Page 135 and 136:
CANopen Programmer’s Manual 4: Co
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Page 157 and 158:
Page 159 and 160:
CANopen Programmer’s Manual 5: St
Page 161 and 162:
Page 163 and 164:
Page 165 and 166:
CANopen Programmer’s Manual 6: Ho
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
Page 177 and 178:
Page 179 and 180:
Page 181 and 182:
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Page 191 and 192:
CANopen Programmer’s Manual 7: Pr
Page 193 and 194:
Page 195 and 196:
Page 197 and 198:
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
CANopen Programmer’s Manual 9: Cy
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
Page 225 and 226:
CANopen Programmer’s Manual A: Al
Page 227 and 228:
Page 229 and 230:
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Page 237 and 238:
CANopen Programmer’s Manual B: Tr
Page 239 and 240:
Page 241 and 242:
Page 243 and 244:
Page 245 and 246:
CANopen Programmer’s Manual C: Ob
Page 247 and 248:
Page 249 and 250:
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257:
CANopen Programmer’s Manual P/N 9
show all

CANopen Programmer's Manual - Maccon.de

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?