WinEMP - NRI
WinEMP - NRI
WinEMP - NRI
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
G-18.2800<br />
Hardware adaptation within the scope of adapting the devices to the Euro<br />
! ! Only in connection with <strong>WinEMP</strong> Euro programming ! !<br />
2. Remove the circuit board<br />
Loosen and remove the 3 screws<br />
shown and pull the circuit board off<br />
the plug in an upwards direction.<br />
Please place the circuit board next to<br />
the ECV.<br />
3. Adapting the components<br />
Cut the connecting wires of the<br />
capacitor and the resistor off above the<br />
cardboard strip and bend the pins to fit<br />
the soldering position shown here.<br />
4. Performing the changes<br />
Solder the pins of the components into<br />
position using additional solder. This area<br />
is covered with sealing varnish and there<br />
are very fine wires already in position at the<br />
points where the capacitor is to be soldered<br />
on! Now you remove the SMD resistor<br />
shown, by desoldering or nipping it.<br />
1. Remove the cover over the<br />
electronic components<br />
After opening the cover shown<br />
on the left hand side, you will<br />
recognize G-18.2800 by the<br />
programming plug positioned in<br />
the right top hand corner of the<br />
circuit board.<br />
CRANE NATIONAL REJECTORS, INC. GMBH<br />
•<br />
Internet: www.nri.de • e-mail: info@nri.de<br />
Screws<br />
5. Final tasks<br />
- Assembling the ECV<br />
- Immediate programming for Euro using <strong>WinEMP</strong><br />
(Please read separate <strong>WinEMP</strong> operating instructions)<br />
- Before using the device as a Euro coin validator we<br />
recommend that you carry out a Euro acceptance test.<br />
SAP 00158<br />
330pF<br />
SAP 00243<br />
470kΩ<br />
a Crane Co. company<br />
Telephone: 04161 / 729-0 Telefax: 04161 / 729-115<br />
D-21614 Buxtehude Zum Fruchthof 6<br />
Connecting plug<br />
Remove<br />
SMD component<br />
in the middle<br />
JBe-02/01 Subject to technical changes!