WinEMP - NRI

WinEMP – G-13.mft CONFIGURATION – FOR MDB/S1 INTERFACE
Coin value/token identification for G-13.mft S1
National Rejectors, Inc. GmbH, Buxtehude
The coin value must be a multiple of the smallest coin value
configured; otherwise the smallest coin value must be
adapted accordingly (see also section "Configure the smallest
coin value as a basis of calculation for coin values" in this
chapter).
1 In the line of the respective coin channel, use the keyboard to enter
the desired coin value or a token identification (TK (standard
value 255)/TK1 (254)/TK2 (253)/TK3 (252)/TK4 (251)) under the
heading CV.
If the required coin value or token identification has not been
configured in another coin channel yet (value/identification is
highlighted in red), for S1 devices the value/identification must firstly
be included in the desired position in the coin type table:
a) Select menu item EXTRA and then BASIC SETTINGS.
b) In the "table of contents" on the left-hand side, select COIN
VALUES.
c) On the right-hand side, behind the heading COIN TYPES, enter the
new coin value in the required position using the keyboard.
You can determine a maximum of 16 different coin types.
d) Confirm your entry with OK.
The box closes and the new coin value/token identification is now
displayed in black, or must still be entered using the keyboard.
2 Click BACK to store the setting in the G-13.mft or proceed to the next
setting on this screen and store all your settings later.
95