WinEMP - NRI

CONFIGURATION – FOR PARALLEL INTERFACE (TOTALIZER)
Deactivate/activate teach mode
82
WinEMP – G-13.mft
The G-13.mft is usually delivered so that you can teach new tokens or coin
types on site on the vending machine in the last eight coin channels (teach
channels). You can either fully deactivate this teach function or make it
possible for fewer coin channels to prevent, if necessary, any teach
channels assigned to important coin types from being overwritten
unintentionally.
If you want to change teach mode settings:
1 Select menu item EXTRA and then OPTIONS.
The dialog box BASIC SETTINGS AND OPTIONS opens. In the "table of
contents" on the left-hand side, the index word TEACH MODE has already
been selected.
To deactivate the function:
2a On the righthand
side, click
TEACH MODE
(remove tick).
Clicking again
would set the
tick again and
activate the
teach mode.
To limit the function to specific teach channels:
2b On the right-hand side under ACTIVATE TEACH CHANNELS click (tick) the box
of the channel number(s) that is (are) to be enabled on site for the
teaching process.
Clicking again would delete the tick and inhibit the channel for the teach
mode.
3 Confirm your entry with OK and close the window again or proceed
to the next setting in this dialog box first and confirm all your settings
later.
4 Click BACK to store the setting in the G-13.mft or proceed to the next
setting on this screen and store all your settings later.
National Rejectors, Inc. GmbH, Buxtehude