WinEMP - NRI

CONFIGURATION – FOR PARALLEL INTERFACE (VALIDATOR)
Configure sorting
56
WinEMP – G-13.mft
If an external sorting device is connected to the coin validator, the following
settings must be performed in WinEMP:
• which sorting control line is to be used to actuate a sorting chute for
the purpose of sorting a specific coin and
• in which period of time is the sorting process to be carried out.
Assign sorting control line to a coin type
If an external sorting device is connected to the coin validator, you can assign
the coin types to be sorted one of three sorting control lines or the return
signal line.
1 In the line of the respective coin channel under the heading
"SORT R 3 2 1" tick the desired sorting control line 1–3 or return signal
line R by clicking on the box and, if necessary,
2 remove the tick set under any other line by clicking the box.
To ensure that the return signal line can be selected for external
sorting it has to be enabled (see section "Enable return signal line
for sorting" in this chapter).
The G-13.mft can then neither send a return signal to the
machine when the return lever/button is operated nor send a
wake-up signal or coin acceptance signal (Casino operation)
to the machine.
3 Click BACK to store the setting in the G-13.mft or proceed to the next
setting on this screen and store all your settings later.
National Rejectors, Inc. GmbH, Buxtehude