WinEMP - NRI

CONFIGURATION
44
WinEMP – G-13.mft
The dialog box which opens shows the international currency acronyms
on the left-hand side (under NAME), on the top right-hand side possible
hardware VARIANTS of the G-13.mft for the currency selected, and on the
bottom right-hand side (under VALUE) all coin types for the currency and
hardware variant selected.
4 Select currency of the new coin to be configured on the left-hand side.
If the required currency is not listed in the data base, the
acceptance bands of these coins are not available for configuration
yet. In this case, first of alle click ALL and then select the currency.
The acceptance bands of these additionally listed currencies must
be taught by coin insertion later on.
5 If necessary, select hardware VARIANT of the coin validator connected
on the top right-hand side (with or without runway limitation (spacer
inside the flight deck, see also spare parts catalogue), large or very
large coins with a diameter up to 32.5 mm or 33.5 mm).
These variants have an effect on the coin acceptance bands
and must always be selected correctly.
6 On the bottom right-hand side, select the required coin type (E =
narrow acceptance band, S = very narrow acceptance band, N/NN/
N1 = new/newer/newest coin of one type, A or no comment = old
coin of one type).
If the required currency or coin type
is not listed in the data base – after
clicking ALL neither, an individual
coin name must be entered by clicking
OTHER.
Entering an individual coin name saves no coin ID, i.e. these
coins cannot be updated by means of a data block download or
duplication. Therefore, please always select a coin from the list,
if possible.
After confirming with OK the acceptance band must be taught by
inserting the corresponding coin.
National Rejectors, Inc. GmbH, Buxtehude