WinEMP - NRI

TABLE OF CONTENTS
4
WinEMP – G-13.mft
5 General program settings 24
Set menu language 24
Set screen colour 25
6 Preparation 26
Check device data and functionality 26
Perform tests 29
Test signal lines (only for parallel interface) 29
Test acceptance gate 29
Display authorization licences of the chip card
Select memory block for configuration
30
(only with double block data-management) 31
7 Measured coin values and channel values 32
Measuring principle of the G-13.mft 32
Which coin type is accepted in which coin channel? 33
8 Configuration
Optimize acceptance of genuine coins and rejection of
35
false coins 39
Teach coin types/tokens in coin channels 43
A Configure G-13.mft for parallel validator operation 46
Assign coin impulse number to a coin type 47
Assign coin signal line to a coin type 48
Define coin impulse length 49
Define attraction time of the acceptance gate and
display pre-magnetization/coin acceptance time and
time periods of the accepted coin sensors 50
Define attraction time of the acceptance gate for
normal acceptance speed 50
Define attraction time of the acceptance gate for
Casino operation (high acceptance speed) 51
Inhibit coin types 52
Activate or deactivate coin types using coin validator
software 52
Assign DIL switch to a coin type/coin group
(only with single block data-management for inhibiting
via DIL switches) 53
Assign external individual inhibit signal line to a coin type 54
Deactivate/activate teach mode 55
National Rejectors, Inc. GmbH, Buxtehude