WinEMP - NRI

WinEMP – G-13.mft
Select memory block for configuration
(only with double block data-management)
National Rejectors, Inc. GmbH, Buxtehude
PREPARATION
The memory block 0 or 1 to be configured does not have to be activated using
the DIL switch on the rear side of the coin validator but can also be selected
with the aid of WinEMP instead.
The currently active memory block is displayed in the program line at the top
of the screen.
If you want to configure or check the data of the other memory block:
Select menu item TESTS in the main menu and then SELECT BLOCK.
After the status-bar indicator has been completed, the activated memory
block is displayed at the top in the program bar and its data is displayed on
the screen.
Before configuring the coin channels, always make sure that
the correct memory block is activated, otherwise the settings
will be incorrect.
When the coin validator is connected to the PC, the data of the
memory block set at the DIL switch is always downloaded.
31