WinEMP - NRI

WinEMP – G-13.mft
National Rejectors, Inc. GmbH, Buxtehude
PREPARATION
The left column displays the device data for the connected G-13.mft:
• ORDER NUMBER/DEVICE NUMBER/ORDERING CODE
(compare label of coin validator)
• Date of programming of all default values
(DATE OF MANUFACTURE)
• Date of last change to the coin validator data
(DATE OF LAST ADJUSTMENT)
With double block data-management,
the upper date applies to memory
block 0, and the lower date applies to
memory block 1. If both memory blocks
were programmed or changed on the
same day, only one date is displayed
(as shown).
• 8-digit number of the current DATA BLOCK in
the device memory and its 3-digit REVISION
NUMBER (update number of this data block)
(compare label of coin validator)
• SOFTWARE VERSION of the G-13.mft
• Status of the CHECKSUMS (RAM or EEPROM)
(OK/ERR)
If one of the checksums is defective (display = ERR), the coin validator
will not accept any coins. The device must then be checked by a service
technician and repaired if necessary.
27