WinEMP - NRI

WinEMP – G-13.mft
National Rejectors, Inc. GmbH, Buxtehude
GLOSSARY
Smallest coin value The smallest coin value for the MDB/S1 and totalizer model
of the G-13.mft is the reference value for data-managing the
→ coin values (and prices). The values of all the coin types
accepted by the G-13.mft must be integral multiples of the
smallest coin value.
Sorting control line The G-13.mft is equipped, for external sorting of the cash-box
coins, with a JST connector with three sorting control lines,
via which the → sorting gates are addressed. These
bidirectional lines can also send "Full" signals in the other
direction to the G-13.mft so that coins are directed into the
cash-box and no longer to an external sorting device. With
the G-13.mft with parallel interface, the → return signal line
can also be used on an alternative basis for the purpose of
sorting.
The G-13.mft with cctalk interface is equipped, for external
sorting of cash-box coins, with a 10-pole connecting plug
with six sorting control lines, via which the eight cctalk sorter
pathes are addressed and the → sorting gates actuated.
Sorting gate The sorting gates are activated depending on the run time of
the accepted coins in the G-13.mft and direct the coins to be
sorted into the return area or coin outlet of the coin validator.
Sorting time The sorting time specifies the switching times of an external
sorting device.
Switching block The G-13.mft has two switching blocks with ten DIL switches
(S1.1–10 and S2.1–10) each. Functions that can be switched
on site are assigned to the individual switches (see separate
instructions for the G-13.mft).
Teach mode In the teach mode the last eight → coin channels
(= teach channels) can be assigned new coin types or tokens
on site on the vending machine, which means that these
newly configured coins are accepted in the respective coin
channel. With WinEMP the teach mode can either be switched
off entirely or limited to fewer teach channels.
Timed-output mode If a game is not to be activated via a short signal but rather via
a constant time signal in the TV totalizer operation of the
G-13.mft → totalizer, you can (in the timed-output mode, can
be activated in WinEMP) use the totalizer's lower switching
block to set a certain period of time.
157