WinEMP - NRI

More documents

Recommendations

Info

144 National Rejectors, Inc. GmbH, Buxtehude Error message Description Cause Remedy Data block download WRONG LIMITS (CHANNEL X, MEASUREMENT X)! WRITE DATA INTO VALIDATOR NEVERTHELESS? NO CURRENT EURO DATA BLOCK! WinEMP discovers faulty actual data WinEMP searches for Euro values in the actual data block (set) entered NO EURO DATA BLOCK! WinEMP searches for Euro values in the new data block (set) entered EURO DATA ERROR! WinEMP searches for Euro values in the actual/new data block (set) entered VALIDATOR CANNOT BE PROGRAMMED TO EURO! ERROR WHEN WRITING THE DATA INTO VALIDATOR! Selecting the function "Data block download" not possible WinEMP cannot read data block data of the connected coin validator WinEMP cannot establish connection to the connected coin validator Actual data differs from the default values on the label of the coin validator Data block (set) should include Euro values. However, WinEMP does not find any Data block (set) should include Euro values. However, WinEMP does not find any Actual data block (set) should include Euro values. However, WinEMP does not find any New data block (set) should include Euro values. However, WinEMP does not find any Chip card inserted does not provide access authorization Invalid device number or data Connection to the coin validator interrupted Configure default values from the label of the coin validator first and then repeat process (see Chap. 8 "Configuration") Configure default values from the label of the coin validator first and then repeat process (see Chap. 8 "Configuration") Contact NRI Configure default values from the label of the coin validator first and then repeat process (see Chap. 8 "Configuration") Contact NRI Repeat process with appropriately programmed chip card Contact NRI Check connection to the coin validator (see Chap. 3 ”Installation”) STATUS AND ERROR MESSAGES WinEMP – G-13.mft
National Rejectors, Inc. GmbH, Buxtehude 145 Error message Description Cause Remedy Data block download ERROR WHEN WRITING ON THE HARD DISC! CHECKING THE DOWNLOADED DATA FAILED! FAILURE WHEN SAVING CHANNELS! FAILURE WHEN INHIBITING CHANEL …! ALL ERROR MESSAGES WITH ERROR CODE ALGO 1 TO 160 WinEMP cannot save the data to be stored on the internal hard disk Data loaded into the connected coin validator is defective Internal hard disk full System error, workplace does not possess access rights to the internal hard disk Data loaded into the connected coin validator is defective Data could not be saved Internal hard disk full Increase memory Internal algorithm error during data block download Software error Contact NRI Entered actual data block set number is not identical to the data block (set) number shown on the label Device data is not identical to data to be loaded from data block (set) Clear up internal hard disk and repeat process Assign system rights to workplace Terminate WinEMP (see Chap. 11 "Exit program"), restart (see Chap. 3 "Installation") and repeat process Enter correct data block set number as shown on the label and repeat process Configure default values from the label of the coin validator first and then repeat process Perform data block download for another device WinEMP – G-13.mft STATUS AND ERROR MESSAGES
Page 1:
Technical Documentation The configu
Page 4 and 5:
TABLE OF CONTENTS 4 WinEMP - G-13.m
Page 6 and 7:
TABLE OF CONTENTS 6 WinEMP - G-13.m
Page 9 and 10:
WinEMP - G-13.mft GENERAL INFORMATI
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
WinEMP - G-13.mft 3 Installation In
Page 17 and 18:
WinEMP - G-13.mft INSTALLATION 7 Pl
Page 19 and 20:
WinEMP - G-13.mft Start WinEMP Nati
Page 21 and 22:
WinEMP - G-13.mft National Rejector
Page 23 and 24:
WinEMP - G-13.mft General operating
Page 25 and 26:
WinEMP - G-13.mft GENERAL PROGRAM S
Page 27 and 28:
Page 29 and 30:
WinEMP - G-13.mft Perform tests Nat
Page 31 and 32:
WinEMP - G-13.mft Select memory blo
Page 33 and 34:
Page 35 and 36:
WinEMP - G-13.mft 8 Configuration N
Page 37 and 38:
WinEMP - G-13.mft G-13.mft with MDB
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
WinEMP - G-13.mft Teach coin types/
Page 45 and 46:
Page 47 and 48:
WinEMP - G-13.mft CONFIGURATION - F
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94: WinEMP - G-13.mft CONFIGURATION - F
Page 115 and 116: WinEMP - G-13.mft Copy and paste or
Page 117 and 118: WinEMP - G-13.mft Change token/coin
Page 119 and 120: WinEMP - G-13.mft National Rejector
Page 129 and 130: WinEMP - G-13.mft After the data bl
Page 133 and 134: WinEMP - G-13.mft 10 Restore G-13.m
Page 135 and 136: WinEMP - G-13.mft WINEMP UPDATE 12
Page 137 and 138: National Rejectors, Inc. GmbH, Buxt
Page 143: National Rejectors, Inc. GmbH, Buxt
Page 147 and 148: WinEMP - G-13.mft C Card reader 10
Page 149 and 150: WinEMP - G-13.mft E ECV 155 totaliz
Page 151 and 152: WinEMP - G-13.mft Return signal lin
Page 153 and 154: WinEMP - G-13.mft Glossary National
show all

WinEMP - NRI

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?