WinEMP - NRI

WinEMP – G-13.mft
10 Restore G-13.mft settings
National Rejectors, Inc. GmbH, Buxtehude
RESTORE G-13.MFT SETTINGS
The software WinEMP enables the user to reverse settings made to the
G-13.mft, i.e. the G-13.mft configuration can be reset to any settings.
To do this, the settings of a G-13.mft must always be made using
the same PC as the backup files have been saved on the
computer’s hard disk and are also retrieved from that hard disk.
When the software WinEMP recognizes the G-13.mft and when the data is
saved in the device after a confirmation request, it creates a backup file in
the archives folder.
If you want to restore a specific G-13.mft setting:
1 In the main menu, select menu item RESTORE.
A dialog box opens.
All the backup files for
the individual
configurations of the
connected device that
were saved on the hard
disk of your PC are
listed in this window
and can be identified
by the adjustment date and a consecutive number set in brackets. The
backup file provided with a "(0)" is the file that was read into the system when
the software was started, i.e. the original state of the respective date. The
file with the highest number is the actual state of the device.
2 Use the mouse to mark the desired file.
3 Confirm your selection with OK.
Following expiry of status bar indication, the data has been restored to the
desired earlier state.
Due to the fact that the backup files that are stored later are not
deleted if the device data is reset, these configurations also remain
available for further use.
133