WinEMP - NRI

WinEMP – G-13.mft GENERAL INFORMATION
National Rejectors, Inc. GmbH, Buxtehude
If you already possess the adapter pack 19.0640, it can be used
instead of the WinEMP PC interface G-55.0359.
The AMU and SGI model as well as coin validators with wake-up
sensor cannot be tested using these testers. A tester for these
models is currently being developed.
... for G-13.mft with parallel interface for testing the signal lines – totalizer operation
Test stand
If the signal lines of the machine interface are to be checked, you will require
an additional tester. The following device environment is required:
• Tester
– G-19.0645 (ordering code 16183) for 220 V AC mains voltage +
WinEMP PC interface G-55.0359 (ordering code 26125)
– G-19.0650 (ordering code 21409) for 115 V AC mains voltage +
WinEMP PC interface G-55.0359 (ordering code 26125)
If you already possess the adapter pack 19.0640, it can be used
instead of the WinEMP PC interface G-55.0359.
The ECV totalizer model as well as totalizers with wake-up sensor
cannot be tested using these testers. A tester for these models is
currently being developed.
Most of all, simplify the testing of the coin acceptance and coin return
functions but also the configuration of the coin validator and use the NRI test
stand G-19.0325 (ordering code 7753) for devices without front plate or
G-19.0326 (ordering code 7754) for devices with front plate.
System requirements
The WinEMP software specifies the following minimum hardware and
software requirements:
Operating system Windows 98/NT/2000/XP (not CE)
Working memory of at least 32 MB
CD-ROM drive
Graphic resolution 800 x 600 dpi min./High Color
USB or COM interface
The use of the WinEMP program as well as the explanations in
these instructions requires basic knowledge of the Windows
operating system on the part of the user.
13