WinEMP - NRI

More documents

Recommendations

Info

CONFIGURATION 122 1 2 3 4 5 WinEMP – G-13.mft 1 Memory block 0 or 1/coin channel number 2 Coin type currently configured in that coin channel 3 Acceptance band status of the relevant coin channel: ACTIVE = Acceptance band of the relevant coin is configured, coin is accepted in this channel INACTIVE = No acceptance band configured, this channel does not accept any coin 4 Coin that is to be configured in the relevant coin channel by means of a download TM/TK = Teach mode, coin channel is prepared by the manufacturer, so that new coins can be taught at the vending machine E = Load coin with narrow acceptance band S = Load coin with very narrow acceptance band N/NN/N1= New/newer/the newest coin of one type A = Old coin of one type 5 Information on acceptance band that is to be configured in the relevant coin channel by means of a download: RE-CALCULATE AB WITH REF. DATA = acceptance band will be accepted from master device DO NOT PROGRAM ANY AB = acceptance band cannot be programmed, must be taught later on ACCEPT AB = acceptance band will be accepted from coin configuration of current channel data, must be readjusted, if necessary UPDATE AB = acceptance band will be accepted from coin configuration of current channel data, but its limits will be updated according to current NRI values, must be re-adjusted, if necessary TOKEN AB CANNOT BE PROGRAMMED = acceptance band for token cannot be programmed National Rejectors, Inc. GmbH, Buxtehude
WinEMP – G-13.mft National Rejectors, Inc. GmbH, Buxtehude CONFIGURATION 6 Close dialog box with OK. WinEMP then transmits the master data into the memory of the connected device. 7 If necessary, disconnect the device and connect the next device to be configured. 8 Repeat steps 5 to 7 for all devices to be configured. 9 Click FINISH to stop series configuration. 10 Check all settings of the duplicated devices. 123
Page 1:
Technical Documentation The configu
Page 4 and 5:
TABLE OF CONTENTS 4 WinEMP - G-13.m
Page 6 and 7:
TABLE OF CONTENTS 6 WinEMP - G-13.m
Page 9 and 10:
WinEMP - G-13.mft GENERAL INFORMATI
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
WinEMP - G-13.mft 3 Installation In
Page 17 and 18:
WinEMP - G-13.mft INSTALLATION 7 Pl
Page 19 and 20:
WinEMP - G-13.mft Start WinEMP Nati
Page 21 and 22:
WinEMP - G-13.mft National Rejector
Page 23 and 24:
WinEMP - G-13.mft General operating
Page 25 and 26:
WinEMP - G-13.mft GENERAL PROGRAM S
Page 27 and 28:
Page 29 and 30:
WinEMP - G-13.mft Perform tests Nat
Page 31 and 32:
WinEMP - G-13.mft Select memory blo
Page 33 and 34:
Page 35 and 36:
WinEMP - G-13.mft 8 Configuration N
Page 37 and 38:
WinEMP - G-13.mft G-13.mft with MDB
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
WinEMP - G-13.mft Teach coin types/
Page 45 and 46:
Page 47 and 48:
WinEMP - G-13.mft CONFIGURATION - F
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72: WinEMP - G-13.mft CONFIGURATION - F
Page 115 and 116: WinEMP - G-13.mft Copy and paste or
Page 117 and 118: WinEMP - G-13.mft Change token/coin
Page 119 and 120: WinEMP - G-13.mft National Rejector
Page 121: WinEMP - G-13.mft National Rejector
Page 129 and 130: WinEMP - G-13.mft After the data bl
Page 133 and 134: WinEMP - G-13.mft 10 Restore G-13.m
Page 135 and 136: WinEMP - G-13.mft WINEMP UPDATE 12
Page 137 and 138: National Rejectors, Inc. GmbH, Buxt
Page 147 and 148: WinEMP - G-13.mft C Card reader 10
Page 149 and 150: WinEMP - G-13.mft E ECV 155 totaliz
Page 151 and 152: WinEMP - G-13.mft Return signal lin
Page 153 and 154: WinEMP - G-13.mft Glossary National
show all

WinEMP - NRI

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?