WinEMP - NRI

WinEMP – G-13.mft CONFIGURATION – FOR CCTALK INTERFACE
Assign DIL switch to a coin type/coin group
(only with single block data-management for inhibiting via DIL switches)
If your coin validator data-manages all 32 coin channels in a single switching
block and, if you want to be able to inhibit individual coin types or a coin group
directly on site using the coin validator with the help of the DIL switches, you
must assign the respective coin types to the first eight DIL switches of the
upper switching block in WinEMP first:
1 In the line of the respective coin channel under the heading "DIL-
INH. 8–1", tick the desired switch by clicking the box and, if necessary,
2 remove the tick set under any other switch by clicking the box.
National Rejectors, Inc. GmbH, Buxtehude
For a group inhibit, assign all relevant coin types (e.g. of a currency)
to the same DIL switch.
Make the setting easier and use the DIL switch simulation at the top
of the screen:
If you set a tick for a specific DIL switch for inhibiting in the
simulation (here: DlL switch 4), WinEMP shows, for convenience, all
the coin channels which have been inhibited via that switch, with a
red bar (to the right of the channel number).
3 Click BACK to store the setting in the G-13.mft or proceed to the next
setting on this screen and store all your settings later.
To inhibit the coin type/coin group all that has to be done is set the appropriate
DIL switch to ON (see also separate instructions for the coin validator).
109