WinEMP - NRI

CONFIGURATION – FOR CCTALK INTERFACE
Inhibit coin types
108
WinEMP – G-13.mft
If specific coins are no longer to be accepted for payment at the vending
machine, your coin channels can either be
• deactivated on a long-term basis using the coin validator software,
• assigned to a DIL switch, which can be used to inhibit the coin
channels on a flexible basis on site (only with single block datamanagement)
or
• inhibited using the vending machine control system.
Activate or deactivate coin types using coin validator software
If individual coin types are to be inhibited in the long term or if certain coin
types have already been configured by the manufacturer but are inhibited
because they have so far not been required (number of the coin channel
marked with a red bar), you have the option of deactivating or activating the
respective coin channels internally using the coin validator software.
The coin channels deactivated using the coin validator software
cannot be re-enabled on the device or using the vending machine
but can only be re-enabled using the configuration software
WinEMP.
1 In the line of the respective coin channel under the heading "X", click
on the box.
A tick is set or deleted (tick = coin type deactivated, no tick = coin
type activated, and the channel number is marked in red or is no
longer marked).
By clicking on the box again, you can cancel the entry.
2 Click BACK to store the setting in the G-13.mft or proceed to the next
setting on this screen and store all your settings later.
National Rejectors, Inc. GmbH, Buxtehude