WinEMP - NRI

CONFIGURATION – FOR MDB/S1 INTERFACE
102
WinEMP – G-13.mft
Assign sorting control line to a coin type (only for G-13.mft with S1 interface)
If an external sorting system is connected to the coin validator, the following
sorting control lines are assigned to the coins to be sorted for a specific
S1 sorting way (binary-coded):
S1 sorting way Sorting control line
1 2 3
0 (cash-box) – – –
1 X – –
2 – X –
3 X X –
4 – – X
5 X – X
6 – X X
7 X X X
Feedback (e.g. "Full signal") from an external sorting device can
only be provided on sorting ways that are addressed via a single
sorting control line (S1 sorting way 1, 2, 4).
1 In the line of the respective coin channel under the heading
"SORT 3 2 1" tick the desired sorting control line(s) 1–3 by clicking on
the box and, if necessary,
2 remove the tick set under any other line by clicking the box (see table
above).
3 Click BACK to store the setting in the G-13.mft or proceed to the next
setting on this screen and store all your settings later.
National Rejectors, Inc. GmbH, Buxtehude