WinEMP - NRI

GENERAL INFORMATION
Additional technical documentation
10
WinEMP – G-13.mft
To facilitate the configuration of your coin validator using the software
WinEMP, these instructions refer to separate technical documentation for
the coin validator and the testers:
• "Electronic coin validator G-13.mft parallel (standard, Casino, SGI,
BDTA and AMU model)" (from model /4 onwards)
• "Electronic coin validator G-13.mft parallel (2-price totalizer, timer and
TV totalizer mode)" (from model /4 onwards)
• "Electronic coin validator G-13.mft MDB/S1" (from model /4 onwards)
• "Electronic coin validator G-13.mft cctalk" (from model /4 onwards)
• "Tester
– G-19.0594/4" (for parallel interface, validator operation)
– G-19.0645“ (for parallel interface, totalizer operation)
If this documentation is not available to you, you can download it at
any time from the NRI homepage (www.nri24.com) in the
compressed PDF format.
General information about the WinEMP software
The WinEMP software is used for diagnostics and individual configuration
purposes and to update the complete coin and device configuration (data
block update) of NRI coin validators and changers.
After every configuration step performed on a coin validator,
please make sure that the label of the device is adapted to
suit the new settings of the device.
The program identifies each connected coin validator including its devicespecific
data and presents this data for diagnostics and configuration
purposes on the screen of your PC.
The card reader connected between the coin validator and the PC to accept
licence-dependent programmed chip cards ensures that only the owner of
the card can configure data at the programming level.
National Rejectors, Inc. GmbH, Buxtehude