Manual

More documents

Recommendations

Info

Tilted position 15 degrees The distance is, contrary to the original 600 mm, only 327 mm. This is very close to the critical point already. Tilted position 30 degrees The water level and the critical point at the exhaust elbow are at the same level now. If the ship is sailed in a tilted position of 30 degrees with an installation like that, the infiltration of cooling water into the combustion chamber is inevitable. Irreparable damages are preprogrammed. Installation Instructions Fig. 5.7.3.2-6: Tilted position 15 degrees Fig. 5.7.3.2-7: Tilted position 30 degrees Summary: Concerning sailing yachts it must be regarded, that the waterlock is mounted in center underneath the generator, at least in reference to the ships’ center line. Thus the waterlock is prevented from „leaking“ very strongly when the ship is tilted. The „leaking“of the waterlock leads to a rise of the water level which then gets too close to the exhaust elbow’s critical point. 5.8 Exhaust / water separator In order to reduce the noise level of the generator unit to a minimum, an optional exhaust outlet muffler can be mounted next to the through-hull fitting. Additionally there is a component at Fischer Panda, which acts as both an „exhaust goose neck“, and water separator. With this „exhaust/water separator“ the cooling water is derived over a separate pipe. The exhaust noises emanating from the exterior of the yacht are strongly decreased. Particularly the „water splash“. Seite/Page 70 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 5: Installation Instructions 7.5.12
Installation Instructions Fig. 5.8.0-1: Installation Scheme exhaust / water separator 7.5.12 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 5: Installation Instructions Seite/Page 71
Page 1 and 2:
Marine Generator Manual Panda 4500
Page 3 and 4:
Inhalt / Contens Marine Generator M
Page 5 and 6:
Inhalt / Contens 5.5 Installation o
Page 7 and 8:
Inhalt / Contens 7.6.2 Measuring th
Page 9 and 10:
Dear Customer, Thank you for purcha
Page 11 and 12:
General Instructions and Regulation
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22: General Instructions and Regulation
Page 23 and 24: General Instructions and Regulation
Page 25 and 26: In case of Emergency First Aid / Im
Page 27 and 28: 3. Basics 3.1 Intended use of the m
Page 29 and 30: An adequate lifting yoke shall be u
Page 31 and 32: Optionales components f.e.: - Fuel
Page 33 and 34: • Short-term standstill (1 to 3 m
Page 35 and 36: epeat procedure twice. • Visual i
Page 37 and 38: The Panda Generator 4. The Panda Ge
Page 39 and 40: The Panda Generator 4.2.2 Left Side
Page 41 and 42: The Panda Generator 4.2.4 Back View
Page 43 and 44: The Panda Generator 4.3 Details of
Page 45 and 46: The Panda Generator 4.3.3 Component
Page 47 and 48: The Panda Generator 4.3.5 CSensors
Page 49 and 50: The Panda Generator Engine oil stra
Page 51 and 52: The Panda Generator 8. Switch the l
Page 53 and 54: Installation Instructions 5. Instal
Page 55 and 56: Installation Instructions Disconnec
Page 57 and 58: Installation Instructions 5.4.2 Fis
Page 59 and 60: Installation Instructions 5.4.5 Gen
Page 61 and 62: Installation Instructions 5.4.7 Gen
Page 63 and 64: Installation Instructions 5.5.2 Sch
Page 65 and 66: Installation Instructions 5.7 .Inst
Page 67 and 68: Installation Instructions exhaust g
Page 69 and 70: Installation Instructions Tilted po
Page 71: Installation Instructions Tilted po
Page 75 and 76: Installation Instructions Fuel hose
Page 77 and 78: Installation Instructions Electrica
Page 79 and 80: Installation Instructions External
Page 81 and 82: Installation Instructions To avoid
Page 83 and 84: Installation Instructions 1. Genera
Page 85 and 86: Installation Instructions 4. (-) ca
Page 87 and 88: Installation Instructions 1. Genera
Page 89 and 90: Installation Instructions Mini VCS
Page 91 and 92: Installation Instructions rate. As
Page 93 and 94: Installation Instructions 2. Open t
Page 95 and 96: Installation Instructions Some gene
Page 97 and 98: Maintenance Instructions 6. Mainten
Page 99 and 100: Maintenance Instructions 6.3 Enviro
Page 101 and 102: Maintenance Instructions Close the
Page 103 and 104: Maintenance Instructions 1. Open th
Page 105 and 106: Maintenance Instructions 6.7.4 Alte
Page 107 and 108: Maintenance Instructions Oil dipsti
Page 109 and 110: Maintenance Instructions 2. Loosen
Page 111 and 112: Maintenance Instructions 6.10 Verif
Page 113 and 114: Maintenance Instructions 2. Press f
Page 115 and 116: Maintenance Instructions Unscrew th
Page 117 and 118: Generator Failure 7. Generator Fail
Page 119 and 120: Generator Failure at full load. The
Page 121 and 122: Generator Failure 1. Countering nut
Page 123 and 124:
Generator Failure Change this fuse
Page 125 and 126:
Generator Failure (notes: the volta
Page 127 and 128:
Generator Failure This period can b
Page 129 and 130:
Tables 8. Tables 8.1 Troubleshootin
Page 131 and 132:
Tables MOTOR SPEED DROPS Generator
Page 133 and 134:
Tables Lubrication oil capacity 2,8
Page 135 and 136:
Tables Panda 7,5-4 Panda 9-4 Panda
Page 137 and 138:
Tables 8.3.1 Coolant mixture ratio
Page 139 and 140:
Remote Control Panel P4 Control Fis
Page 141 and 142:
Remote Control Panel P4 Control 9.2
Page 143 and 144:
Remote Control Panel P4 Control Fis
Page 145 and 146:
Fischer Panda Datenblatt / Datashee
Page 147 and 148:
Fischer Panda Datenblatt / Datashee
show all

Manual

Create successful ePaper yourself

Delete template?

Save as template?