Manual

5.5 Installation of the cooling system - fresh water
5.5.1 Position of the external cooling water expansion tank
Position of the external cooling water expansion tank
The Panda generator is normally supplied with an additional, external cooling
water expansion tank. This tank must be installed in such a way that its
lower edge is at least 500 mm more highly arranged than the upper edge of
the sound cover.
If this 500 mm should be fallen below, i.e. the cooling water expansion tank
is lower installed, very large problems can occur with filling and ventilating.
Extend and displace the hose lines to the outside or possibly even up to the
deck.
The external cooling water expansion tank may be filled only
up to the lower edge of the lower tension tape (see note „max“)
in the maximum filling level in cold condition.
Installation Instructions
Fig. 5.5.1-1: Position of the External Cooling Water Expansion
ATTENTION!
Seite/Page 60 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 5: Installation Instructions 7.5.12
Tank