Manual
Manual
Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.2.3 Advice for optimal sound insulation<br />
The convenient base consists of a stable framework, on<br />
which the generator is fastened by means of shockmounts.<br />
Since the aggregate is „free“ downwards, the<br />
combustion air can be sucked in unhindered. In addition<br />
the vibrations are void which would arise with a closed<br />
capsule base.<br />
5.3 Generator Connections - Scheme<br />
See chapter „The Panda Generator for the original position of the connections<br />
All electrical wires are connected tightly to the motor and the<br />
generator. This is also the case for fuel lines and cooling water<br />
lines.<br />
Fig. 5.2.3-1: Generator base<br />
Installation Instructions<br />
The electrical connections must be carried out according to the respective valid regulations. This also concerns used<br />
cable materials. The cables supplied are meant for laying „protected“ (i.e. in pipe) at a temperature up to a max. of<br />
70 ° C (160 ° F). The on-board circuit must also be fitted with all essential fuses.<br />
Before working (installation) on the System read the section<br />
Cooling System Installation - Raw water<br />
See chapter 3 for the original position of the connections<br />
ATTENTION! 7<br />
5.4 Installation of the cooling system - raw water<br />
5.4.1 General information<br />
The genset should have its own raw water (coolant water) inlet and should not be connected to any other engine<br />
systems. Ensure that the following installation instructions are complied with:<br />
Seite/Page 54 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 5: Installation Instructions 7.5.12