Manual

Generator Failure
7. Generator Failure
7.1 Personal requirements
The work described here, unless otherwise indicated, are performed by the operator.
More repair work may be performed only by specially trained personnel or by authorized repair shops (Fischer
Panda service points). This is especially for working on the valve timing, fuel injection system and the engine repair.
7.2 Hazard notes for the troubleshooting
Follow the general safety instruction at the front of this manual.
Danger for life! - The generator can be equipped with an automatic
start device. This means the generator can be started by
an external signal. To avoid an unexpected starting of the generator,
the starter battery must be disconnected before start
working at the generator.
Working at a running generator can result in severe personal
injury. Therefore before starting work at the generator:
Make sure that the generator is stopped and the starter battery is disconnected
to guarantee that the generator cannot be inadvertently started.
Do not run the generator with removed sound isolation cover.
Improper installation/maintenance can result in severe personal
injuries or material damage.
• Always undertake installation/maintenance work when the
generator is switched off.
• Ensure there is sufficient installation clearance before start
working.
• Ensure tidiness and cleanliness at the workplace. Loose
components and tools lying around or on top of each other
are sources of accidents.
• Only perform installation work using commercially available
tools and special tools. incorrect or damaged tools can result
injuries.
Oil and fuel vapours can ignite on contact with ignition
sources. Therefore:
• No open flames during work on the generator.
• Do not smoke.
• Remove oil and fuel residues from the generator and floor.
Notice!:
Warning!: Automatic start
Warning!: Risk of injury
Warning!: Risk of injury
Warning!: Danger of fire
7.5.12 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 7: Generator Failure Seite/Page 115