Manual
Manual
Manual
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Maintenance Instructions<br />
2. Press failure bypass switch and keep firmly pressed.<br />
The electrical fuel pump must be audible. Switching on<br />
and off the solenoid valve at the generator will be audible<br />
by pressing the failure bypass switch (if capsule<br />
removed).<br />
3. Pressing the failure bypass switch for approx 3 - 4 minutes<br />
will loosen the ventilation screw located at the fuel<br />
solenoid valve. The button must continue to be pressed,<br />
whilst opening the screw. A large cloth or Kleenex tissue<br />
must be laid beneath the connection to prevent escaping<br />
fuel running into the capsule. If the fuel runs out without<br />
air bubbles, then the ventilation screw can be closed.<br />
Only then may the button be released.<br />
Use spanner size 10mm.<br />
Not all generator models has a fuel solenoid valve. At generators<br />
without fuel solenoid valve, a single ventilation screw is<br />
installed.<br />
4. Pressing the starter button can now start the machine.<br />
The machine should start after a short period.<br />
5. If this does not occur, then a connecting nut fitted to the<br />
injection line must be loosened and starting procedure<br />
repeated. Retighten the washers after successfully starting.<br />
The injection line must be raised by several millimetres.<br />
Use spanner size 17mm.<br />
6. Switch main switch „OFF“<br />
Note!:<br />
Fig. 6.11-1: Failure bypass switch<br />
Fig. 6.11-2: Ventilation screw at the fuel solenoid valve<br />
Fig. 6.11-3: Injection nozzles<br />
7.5.12 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 6: Maintenance Instructions Seite/Page 111