Manual
Manual
Manual
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Maintenance Instructions<br />
Oil dipstick EA 300 Engine<br />
The oil-level is to be checked by means of the oil dipstick. The prescribed filling<br />
level must not cross the „Max“-mark.<br />
We recommend an oil-level of 2/3.<br />
Sample picture<br />
Fig. 6.8-2: Oil dipstick<br />
Oil should be refilled, if the oil-level is under 1/3 between the minimum and the maximum mark.<br />
Fischer Panda recommends an oil-level of 2/3 between the minimum and the maximum mark.<br />
If the oil-level is under the MIN-mark, check how many operating hours went by since the last oil change, by means<br />
of your service manual or an existing oil change tag. - with operating hours between 50 and 150 hours it is only necessary<br />
to refill oil. See „Refilling oil“ on page 2.<br />
• with 150 operating hours or more the oil should be changed (See your generators’ service table)<br />
• if the oil-level is under the minimum mark by less than 50h, there might be a technical problem! In that case, we<br />
recommend going to a shop or a Fischer Panda service point.<br />
• if the oil is cloudy or even „creamy“, coolant might have mixed with the oil. See a garage or a Fischer Panda service<br />
point immediately.<br />
6.8.1 Refilling Oil<br />
You require:<br />
Engine oil<br />
1. Check oil-level as described under „Checking oil-level“ on page 1.<br />
2. Oil dipstick is pulled out of the check rail.<br />
3. Open the oil filler cap.<br />
4. Fill in oil (approx. 1/2 litre) and wait for about 2 min. so this it can flow into the oil pan.<br />
5. Wipe off the oil dipstick and put it into the check rail.<br />
6. Pull the oil dipstick out of the check rail and check the oil-level. See „Checking oil-level“ on page 1.<br />
If oil-level is still too low (under 2/3): repeat steps 4-6.<br />
6.8.2 After the oil level check and refilling the oil<br />
Oil Min.<br />
• Put the oil dipstick back into the check rail.<br />
• Close the oil filling cap.<br />
• Remove potential oil stains and splashes from the generator and surroundings.<br />
• Close the generator casing.<br />
• Remove lock against accidental generator start.<br />
Oil Max.<br />
2/3 Suggestion<br />
7.5.12 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 6: Maintenance Instructions Seite/Page 105
Change language