Manual

Pull to the impeller with a multigrip pliers of the wave.
Mark the impeller, to make sure that these is used in the correct position at
re-installation.
Representative picture
Check to the impeller for damage and replace it if necessary.
Before the reinsertion into the housing the impeller should have been lubricated
with glycerin or with a non-mineral oil based lubricant e.g. silicone
spray.
The impeller is attached to the pump wave (if the old impeller is used, pay
attention to the before attached marking).
Representative picture
Fastening the cover and use a new seal.
Representative picture
6.7.2 Replace the air filter mat
Maintenance Instructions
Fig. 6.7.1-4: Impeller pump
Fig. 6.7.1-5: Impeller
Fig. 6.7.1-6: Gasket
Seite/Page 100 Panda_4000s_PMS_SCB_FCB_eng.R04 - Kapitel/Chapter 6: Maintenance Instructions 7.5.12