Premier 48, 88, 168 & 640 Installation Manual - PVK

Programming the Control Panel Premier 48, 88, 168 & 640 Installation Manual
System Options
Yes
2 abc
Yes
Yes
No
7 pqrs
Yes
Use the YES key to move
to the next option or use
the SCROLL key to search
Press NO to edit
the volume level
Enter a value or use the
SCROLL key to increase
or decrease the value
e.g. 8 = Full Volume
These options control various system functions.
1 - Advisory Volume
Controls the volume of advisory tones (entry/exit etc.) from
loudspeakers connected to the control panel (Alarm tones are
always full volume). 1 = min, 8 = max.
2 - Chime Volume
Controls the volume level of Chime tones from ALL
loudspeakers. 1 = min, 8 = max.
3 - No. Of Re-Arms
Controls the number of times that a zone will re-arm. Once the rearm
limit has been reached, the zone is ‘Locked Out’ and will not
cause any further Intruder alarms.
4 - Anti-code Resets
Limits how many times a user can perform an Anti-code reset.
Once this limit is been reached, the system can only be reset
using an Engineer code. This counter is reset every month or
whenever an Engineers code is entered.
5 - Multiple Knocks
Controls how many times, a zone with the ‘Double Knock’
attribute, must be activated, before an alarm occurs. The
multiple knock count can be applied to zones on an area
basis, see page 42 for details.
6 - Clock Adjustment
Adjusts the accuracy of the clock by subtracting or adding
time in seconds at midnight every night. 0 = -50, 50 = 0 (no
correction), 100 = +50.
7 - Quick Count
Set the number of 10milli Second pulses that are required
within 30 Seconds in order for a zone with the ‘Quick
Response’ attribute to activate.
8 - Modem Level
When using a Com2400 this option allows adjustment to the
attenuation of the modem.
Modem Level 2 1 0 7 6 5 4 3
Attenuation (dB) +4 +2 0 -2 -4 -6 -8 -10
Monitor Hardware
48 INS176
Yes
3 def
Yes
No
No
Yes
Press NO to edit
the options
Use keys 1 - 8 to select
an attribute or use the
SCROLL key to search
Press NO to
select/deselect
the option
The control panel monitors many inputs for fault conditions
i.e. the panel lid tamper, bell tamper, aux fuse etc.
Each one of these options can be disabled to overcome
problems related to the devices being monitored.
P - Phone Line Fault
The telephone line is monitored for faults.
A - AC Power Failure
The AC Mains is monitored for faults.
F - Aux Fuse Blown
The Auxiliary Fuse/PTC is monitored for faults.
B - Bell Tamper
The external sounder tamper loop is monitored for faults.
A - Aux Tamper
The auxiliary tamper loop is monitored for faults.
L - Panel Lid Tamper
The control panel lid tamper is monitored for faults.
B - Battery Faults
The dynamic battery test is enabled.