Hardware-Manual - eigerGraphics

Hardware-Manual
CN6 Analog Input for Potentiometer
Connector
type
TYCO CST100 3-Pol Wiring Harness: AMP MTA100 3-Pol
Pin 1 L3V3 Logic +3.3V
Pin 2 PA0 Analog IN
Pin 3 LGND Logic Ground
eigerScript eVM Command-Class: InOut
InOut.Read_ADC( VarInt:Kanal_PA0 , VarInt:Value_0-1023 )
Circuit examples
Use of a potentiometer by the use of analog input PA0:
Use of an NTC (e.g. as temperature sensor) by the use of analog input PA0:
CN6A / CN6B BUS, Serial Interface RS485
Matching cable: F4336
Connector type Molex MiniFit jr. 5566 4-Pol Wiring Harness: Molex MiniFit jr. 5566 housing 4-Pol
Pin 1 L12V Logic +12V
Pin 2 RXTX- RS485 Line minus
Pin 3 LGND Logic Ground
Pin 4 RXTX+ RS485 Line plus
Matching cable: F4368
< Contents
eigerScript eVM commands of class DataServer:
DataServer.ReceiveToFile( VarInt:NodeAdress , VarStr:FileName )
DataServer.ReceiveToString( VarInt:NodeAdress , VarStr:ZielString )
DataServer.Rx_ReadInteger( VarInt:NodeAdress , VarInt:Register , VarInt:Value )
DataServer.Rx_ReadLong( VarInt:NodeAdress , VarInt:Register , VarLong:Value )
DataServer.Rx_String( VarInt:NodeAdress , VarInt:Register , VarLong:Value )
DataServer.SendFromFile( VarInt:NodeAdress , VarStr:FileName )
DataServer.SendFromString( VarInt:NodeAdress , VarStr:QuellString )
DataServer.Tx_Command( VarInt:NodeAdress , VarInt:Register , VarInt:Command )
DataServer.Tx_String( VarInt:NodeAdress , VarInt:Register , VarStr:String )
DataServer.Tx_WriteInteger( VarInt:NodeAdress , VarInt:Register , VarInt:Value )
DataServer.Tx_WriteLong( VarInt:NodeAdress , VarInt:Register , VarLong:Value )
eigerScript eVM commands of class Debug:
Debug.Mark( Str )
Debug.DumpBytes( VarInt )
Debug.Print_IntegerHex( Str , VarInt )
Debug.Print_LongHex( Str , VarLong )
Debug.Print_SingleHex( Str , VarSingle )
Debug.Print_Char( VarInt )
Debug.Print_CLRF( )
Debug.Print_String( VarStr )
Debug.Print_StringHeader( VarStr )
< Contents
Seite 9 von 17
Gewerbestrasse 6 CH-6314 Unterägeri www.eigergraphics.com