Hardware-Manual - eigerGraphics

Hardware-Manual
CN2 S-PROG20 Download / Debug (FOX-COM1, UART1)
Connector type Molex C-Grid III 10-Pol Wiring Harness: Molex C-Grid III connector housing 10-Pol
Pin 1 HOLD /Hold Line
Pin 2 LGND Logic Ground
Pin 3 BYTE Byte Line
Pin 4 L12V Logic +12V
Pin 5 CNV Cnvss Line
Pin 6 L3V3 Logic 3.3V
Pin 7 RES /Reset Line
Pin 8 LGND Logic Ground
Pin 9 TXD_1 S-PROG20 Transmit Line
Pin 10 RXD_1 S-PROG20 Receive Line
eigerScript eVM commands of Class Debug:
Debug.Mark( Str )
Debug.DumpBytes( VarInt )
Debug.Print_IntegerHex( Str , VarInt )
Debug.Print_LongHex( Str , VarLong )
Debug.Print_SingleHex( Str , VarSingle )
Debug.Print_Char( VarInt )
Debug.Print_CLRF( )
Debug.Print_String( VarStr )
Debug.Print_StringHeader( VarStr )
Circuit examples
Connection of a reset key:
Connection to the debug- and programming-Interface:
(F4337)
CN3 Analog Outputs for Sound DA
matching cable: F4337
Connector type TYCO CST100 4-Pol Wiring Harness: AMP MTA100 4-Pol
Pin 1 OP93 Analog Out / Sound DA Out
Pin 2 LGND Logic Ground
Pin 3 OP94 Analog Out / Sound DA Out
Pin 4 L5V Logic +5V
matching cables: F4388 , F4389
< Contents
eigerScript eVM commands of class Sound:
Sound.SetSamplingRate( VarInt:SamplingRate_11025 )
Sound.SetBitsPerSample( VarInt: BitsPerSample )
Sound.PlaySamples( VarInt:Sound_MODE_STEREO , VarStr:File , VarLong:StartOffset ,
VarLong:NoOfSamples , VarInt:Loops )
Sound.InstallLocal( labelRelative24:Event )
eigerScript eVM commands of class File:
File.Read_ToBuffer( VarInt:Handle.I , VarStr:Buffer , VarLong:Offset
, VarLong:NumBytes , VarLong:BytesRead )
Seite 5 von 17
Gewerbestrasse 6 CH-6314 Unterägeri www.eigergraphics.com