A User's Manual for DELSOL3 - prod.sandia.gov - Sandia National ...

SMULT
IPLFL(1)
(I=l ,NUMOPT)
IPROPT
IHOPTP
IOTAPE
198
rectangle relative to the center of the first
rectangle. ALP(1) is the angle in degrees
that the Ith rectangle is rotated about its
center from the N-S, E-W orientation (positive
angles represent a clockwise rotation when
viewed from above). SLEW(1) and SLNS I) are
the lengths of the sides of the Ith rectang i e
that, prior to rotation by ALP(I), were
parallel to the E-W and N-S axes, respectively.
Constraint: NLAND 5 5
Default: NLAND = 0
ALP, CLE, CLN, SLEW, SLNS = 0
(II.B-4,IV.C-4)
Solar multiple at design point; l/SMULT of the thermal
power at the base of the tower goes directly to the
industrial or electrical process at the design point; the
remainder is sent to storage. This variable should be
consistently defined in Namelist NLEFF.
Constraint: SMULT 2 1.0
Default: SMULT = 1.5 (1V.C-5,VI)
Parameter identifying the subset of the NUMOPT power
levels at which field layouts are printed and descriptions
of optimized system are written on Unit 30 if desired:
= 0, no field layout output for the Ith power level;
= 1, output generated for Ith power level.
Constraint: Maximum number of nonzero IPLFL's = 5
Default: IPLFL = 20'0
(VI. A- 5)
Parameter for detailed output of zone by zone field buildup
(IPROPT = -1 is strongly recommended):
= 0, output suppressed;
= 1, output printed. (Note: this option generates a
large amount of output);
= - 1, limited output printed during optimization.
Shows some detail of search and provides useful
output even when program runs out of time.
Default: IPROPT = -1
Parameter for detailed print out of heliostat density
optimization :
= 0, output suppressed
= I, output printed (Note: this option generates
a large amount of output).
Default: IHOPTP = 0
Parameter specifying if user desires to write the results
of an optimization run on Unit 30 to save as a permanent file,
or to rerun for a detailed performance calculation, or both: